missing transponders dvbdream

[ctjrbrown]

Can any one tell me what the correct lnb settings are for dvb dream? I am running dual lnb's. I know the lnbs are not bad because I have a stb that can see the transponders. I have tried hooking directly to the lnb with out a switch and still am having problems. I have also taken the stb out of the picture with the same results.
Any help would be greatly appreciated.

[hiller65]

What kind of lnb are using?

Hiller65

[hiller65]

I am not sure what your asking/what the exact problem is, but I am guessing you have your disecq settings wrong. If that is not your problem, you will have to give more information in order to pinpoint what your problem is.

Your disecq settings for a legacy set up for 110 & 119 (you gave no info, so I will use these two as examples):

KU Circular

Lof-1 11250000
Lof-Sw 0
Lof-2 11250000

Your disecq settings for a Dp set up for 110 & 119:

NA Bandstacked DP KuHi (DBS)

Lof-1 11250000
Lof-SW 0
Lof-2 14350000

You could go to transponders and manually input the transponders you are missing.

Hope this helped.

Hiller65

[ctjrbrown]

WHat I am seeing is transponders with no signals that I know should have a signal. One that I know is missing on sat 110 is 12253. I have tried a disq swith and hooking straight to the lnb with the same results. I have tried avery seeting I can with the same results. I can see the transponder and get a signal on my stb with no problem.

[hiller65]

Have you tried to scan any of the birds yet? Go to scan and click on menu and then right click and go to scan with no signal. After this you should see signal on the transponders, along with all your channels.

Hiller65

[ctjrbrown]

I have tried this several times. I have a background in eletronics and this has me puzzled. I am only having this problem with the twinham 1020g card and not the stb's . I am signals on 91, 110, 119. I am seeing a few transponders on all 3.

[hiller65]

Are you using a 1020a card or a 102g card? Have you tried a different ini file for the transponders?

Hiller65

[ctjrbrown]

I am using the 1020A card. I have tried that with no success. I even check some of the transponders that I know should have signal on but don't with the twinham dtv program and can not see them there either.
This is my first expeirence with a dvb card and think I might just have a bad one.

[hiller65]

I doubt you have a bad card. The learning curve with dvb cards is large but worth it in the end. We just have to figure out what your missing or doing wrong. Have you downloaded all your Twinhann drivers from their web site? Are you sure your Lnb settings are correct (look under disecq on DvbDreams screen) and let me know. What kind of lnb are you using? (legacy?,Dish Pro?, legacy quad?. etc.)

Hiller65

[ctjrbrown]

I have had the best results using the legacy setting for the lnb. I have not tried upgrading the drivers for the card I will try that next.